KymcoForum.com

With 840 or so miles on my 2015 Like 200i, I've noticed the CELP blinking when first turned on.  This may have happened before and I didn't notice, but here's the sequence: turn key to "on," light goes on 2 seconds, off 3 seconds, on 1 second, off, on 1/2 second.  That looks like a code 11, but it's not exactly as the Cyclepedia Service Manual describes how the CELP is supposed to behave.   The manual (p 241) says the light should be off for 5 seconds (not 3) after the initial 2 on, followed by the first code, 3 seconds off, the second code, etc., and then the codes repeat (p 240) after 5 seconds off.  My "11" doesn't repeat.  I also tried resetting the self-diagnosis memory using the throttle method for "early models" described on pp 241-242.  No change. The manual (p 243) says that in later models (the manual is copyright 2014 and my scoot is a 2015) after the codes cycle four times, the codes clear from the system memory.  Did Kymco change the CELP sequence after the manual was published?  Is this not a trouble code at all?  Is there a later manual?  Thanks!

Some of the maintenance intervals on my Like 200i call for checking with a diagnostic tool. Is there an economical DIY alternative to bringing it to the shop?

Sent from my LG-D850 using Tapatalk