Show Posts
1
LIKE 200i / Almost at wits end trying to start 2014 200i 'project'. Any ideas??
« on: November 04, 2016, 07:00:55 PM »
Looking for forum help.
Been lurking for a little while on these forums. I have 2 running 200i (2013 red and 2014 blue and white LX) and picked up a non-running 2014 200i as a project. (can't get enough can we?)
So, I have read and tried all the advice on getting it to run with no luck at all. The battery was low when I got it, so, charged overnight.
It turns over, but won't run. The CELP code was 12 so I replaced the fuel pump (the eBay one in other forums).
Replaced battery, replaced spark plug(iridium), cleaned tank and put in fresh gas. Now the fuel pump runs continuously, checked the fuel pump relay with one from another same year 200i and is OK. It will sometimes start, run for about 5-10 seconds, then dies like fuel starved. The CLEP now does not come on for initialization, but gives 1 blink when turning over. Also checked the fuel injector and has a ohm reading of 14.8 instead of 11.7. Replace? Also I've done all the resets I have read about...
HELP!!! dealer here is a no-go-to.
Been lurking for a little while on these forums. I have 2 running 200i (2013 red and 2014 blue and white LX) and picked up a non-running 2014 200i as a project. (can't get enough can we?)
So, I have read and tried all the advice on getting it to run with no luck at all. The battery was low when I got it, so, charged overnight.
It turns over, but won't run. The CELP code was 12 so I replaced the fuel pump (the eBay one in other forums).
Replaced battery, replaced spark plug(iridium), cleaned tank and put in fresh gas. Now the fuel pump runs continuously, checked the fuel pump relay with one from another same year 200i and is OK. It will sometimes start, run for about 5-10 seconds, then dies like fuel starved. The CLEP now does not come on for initialization, but gives 1 blink when turning over. Also checked the fuel injector and has a ohm reading of 14.8 instead of 11.7. Replace? Also I've done all the resets I have read about...
HELP!!! dealer here is a no-go-to.