Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - number40Fan

Pages: [1]
1
Side By Side / Re: 450i - Does it fit? Long bed, tail gate up?
« on: April 27, 2017, 09:47:58 PM »
Specs list the wheel base at 72" with a 25" tire.  At 97", it will be a tight fit.  Looks like the front plastic will have to go though.  The front tire will have to touch the front of the bed and the rear tire against the tail gate. 


2
Side By Side / Re: 450i - Does it fit? Long bed, tail gate up?
« on: April 25, 2017, 02:59:22 PM »
Quote from: airshot on April 24, 2017, 11:00:33 PM
    The 450i takes up 102" in length without any front brush gard, just stock, so go measure your truck..

8' bed.

I had a Kawasaki Mule 610 XC that I had to pull the front plastic "bumper" off of to get it to fit. 

I really don't want to waste the time making the trip without knowing for sure.  It will be used for hunting and I tow a camper, so the tail gate will need to be up.  If anyone has a measurement of the length from the front of the front tire to the rear of the rear tire, that might help.  Or even the very most front of the 450i to the back of the rear tire.  The tires of the Mule fit in the bed, but the bed of the Mule was hanging past the tail gate some.

3
Side By Side / 450i - Does it fit? Long bed, tail gate up?
« on: April 24, 2017, 05:59:07 PM »
I have been reading up on these side by sides and have finally made the decision to purchase one.  Found a dealer that is a couple hours away from me with a few in stock.  I spoke with him on the phone and asked about the ability to fit them in a long bed pickup with the tail gate up.  I could have sworn I read somewhere that they would, but can't find it now, and he says it won't.

Well, can it?

Pages: [1]