KymcoForum.com

Scooters - 50cc => Agility 50 => Topic started by: Isher on March 13, 2018, 03:24:06 AM

Title: Agility 50 4T exhaust removal
Post by: Isher on March 13, 2018, 03:24:06 AM

It's a 2007.  I see one particular bolt that's a thorn in my side.  It looks like a Torx T45 head.  I haven't tried an impact, but I have tried PB Blaster and a ratchet, and I cannot get the thing to budge.  Is it held in with red Loctite or something?

Title: Re: Agility 50 4T exhaust removal
Post by: JJJoseph on April 28, 2018, 07:34:30 AM

Post a photo so we know what you're talking about.  What you're describing doesn't sound right.

Title: Re: Agility 50 4T exhaust removal
Post by: Tonyov on April 28, 2018, 04:14:54 PM

I also have a 2007 and know exactly what your on about, i am in the process of renewing my exhaust so i will pass any info on if i decide to fit it myself

Title: Re: Agility 50 4T exhaust removal
Post by: Tonyov on May 18, 2018, 06:30:55 PM

Ok, so i have my new exhaust and gonna fit tomorrow. I used a T45 torx on the aforementioned bolt. I attached the torx to half inch t-bar socket and used an extension for leverage, came undone very easily using this method. Hope this helps.

Title: Re: Agility 50 4T exhaust removal
Post by: blue on May 20, 2018, 09:04:21 AM

If its the first time the muffler has been off then yes it might take a little extra torge to remove.When puting back on just go a little extra hand tight those bolts brake easy. Good luck.