LIKE200i rear wheel removal, REVISED

[Stig / Major Tom]

Hi:  I have a 2012 Like 200i, 25K miles.  Recently had rear tire replaced and discovered two problems:  1)  one of the exhaust studs had broken off.  Therefore the muffler is now attached by only one stud at the engine.  Is the stud threaded and can be removed and replaced, or is it pressed in and must be drilled?  2)  The metal clip that bolts to the right front side of the fender hugger (mud guard) had broken.  Thus the hugger was unstable, rubbed on the tire, and the hugger was destroyed.  I found a new hugger online, but have not been able to find a part number for the clip.  Local dealers are clueless.  Any ideas?  In the mean time I'm riding without the hugger.  Thanks!

Hi Craig, welcome to the forum.
As for the exhaust studs - Yes, the two studs are threaded in.
Part # 90033BOLT STUD 8*32
90033-GFY6-C00

If not readily found - probably close , or the same, as used on other scoots (parts on ebay)

seen here....
https://solanocycle.dealerspikeparts.com/oemparts/a/kym/5b50e9a587a866110c2e0972/cylinder-head

Good luck.
Stig

[Ruffus]

@Craig,
maybe that helps..

[CraiginSB]

Thanks Ruffus, Stig, and big Blue.  The link to Solano Cycles really helped.  Yep, the right side clip is 11207, and the left side stay is 11208.  Looks like the intake studs are 90033 the exhaust side studs are 92900 if I interpret the drawings correctly.  Now just have to find them!  Thanks all.

[Stig / Major Tom]

Thanks Ruffus, Stig, and big Blue.  The link to Solano Cycles really helped.  Yep, the right side clip is 11207, and the left side stay is 11208.  Looks like the intake studs are 90033 the exhaust side studs are 92900 if I interpret the drawings correctly.  Now just have to find them!  Thanks all.

Yep, you're right, I correctly identified the wrong studs.😊
The exhaust studs are the 2 below.
I swear that I've seen them sold on ebay for other Chinese scooters - often with those long cap nuts included., for a couple of bucks.
Stig

[Ruffus]

@Craig,
mentioned studs are
# 90033 exhaust side 6×60mm
# 92900 intake side 8×32 mm
drawing lies a little bit.
This studs are standard items and could be easily obtained from any car or motorcycle shop. Just go in some mechanic shop and ask one of the guys to check his/her toolbox. Most good mechanics have some spare stashed somewhere. Or can pretty fast made from a good quality 6 mm bolt (grade 10.8 or higher).