Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Danny Walleye

Pages: [1]
1
Technical | How To / Flashing Relay on Kymco Vitality 50 4T
« on: October 14, 2014, 02:50:59 AM »
I know this a dumb question but where is the turn signal flashing relay on a 2007 Kymco Vitality 50 4T? I cannot find it in my parts manual either.

2
Technical | How To / Directional Lights on 2005 Vitality 50
« on: August 27, 2014, 12:32:33 AM »
Yesterday I turned on my left blinker at an intersection. The blinker began flashing extremely fast and then stopped working. My left blinker stopped working as well but my headlight stayed lit. (I forgot to check my rear lights.) Today everything works fine. I'd appreciate any input on what could be the problem.

3
General Discussion / Starting Problems - SOLVED
« on: July 13, 2014, 10:46:50 PM »
SOLVED - My Vitality 50 starts fine with the kick start but doesn't start when I use the electric start. The engine turns over fine but doesn't pop.

Any thoughts?

4
General Discussion / 2007 Vitality 50 2T
« on: July 13, 2014, 07:51:57 PM »

Never mind...I found the problem: a broken ground wire.


5
Technical | How To / Directional Lights Don't Work At Idle
« on: May 26, 2014, 02:23:32 AM »
The blinkers (turn signals) on son's Vitality 50 do not work when he applies the brakes or when the engine is at idle speed. A strange buzzing sound comes from the front of the scooter when he turns on the blinkers. Any help would be appreciated.

6
Technical | How To / vitality 50 2T
« on: May 04, 2014, 01:18:13 PM »
My son purchased a 2007 Vitality 50 2T (2 stroke) with a non-functioning electric start system. The kick start works well so the previous owner never bothered to fix the electric start. Since I already know the battery is not the problem, I thought I'd take a look at the electric start switch in the handle. I removed the screws holding the throttle assembly together and used my multimeter to verify the start switch is functioning properly (it is). I put the assembly back together but now I can't get the moped to start (using the kick start). It doesn't even pop. What could I have messed up?

Pages: [1]