Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GorgeZeph

Pages: [1]
1
General Discussion / Re: Downtown 300i first impressions
« on: August 13, 2010, 02:15:52 AM »
My first Impressions - Kymco Downtown 300i

I had a chance to see the new Kymco Downtown 300i at the Maxi-scoot Northwest rally in the gorge. I want to preface my thoughts with the disclamier that the ones I saw were demos. I don't know how close these were to the final US version, but I betting it isn't far off.

Styling
   This is a great looking modern maxi scooter. It has a psudo two tone sport bike look. The colors I saw were black, grey, and burnt orange. I'm so happy to see the burnt orange. It not only looks good, but it is easier to see on the road. This is a welcome departure from the trend of black, white, and grey that the other manufacturers seem intent on making us drive.

The two tone effect comes from the black and grey accents. The overall look is sportbike. The headlights have a LED encircled headlamp with two additional highbeams. The dash has a gloss black center section with a very nice handle bar cover.

High Points
   The overall look is wonderful. The seat looks like it would handle a days ride without a wimper. The gages are nice looking and easy to read. There are power points in the small dash box, on the handle bar cover, and under the seat. The one I saw had an unusual termination on the power point under the seat, but that may be for the demo only.

Low Points
   The afore mentioned under seat power point should be standardized. Also, the light under the seat is at the bottom of the box. If you put anything in there, you cover it up. I noticed that the demo had an owners manual on top of it, totally negating the benefit.. The under seat box is also hard plastic. That's it, no pading. I would like to see the box lined to keep up with the competition in this class.

The box on the dash is rather small, big enough for a cell or MP3 player however. While the seat looks great, there is no driver back rest. As someone with a bad back, I would really like that as an option. The only other thing I found to pick on is the tail lights. Although they were great looking, the demo I saw didn't look very bright. This could be remedyed by some aftermarket LED's or add on lights.

Generally
This is a great bike. The overall finish is wonderful. Things are well thought out, much better than some of the more established brands. It weighs in about 100 pounds less than a Burgman 400. This is no small point when things get tight. Could some things be better? Sure, but that is why there is the aftermarket.

For a great on the rode impression check http://www.soundrider.com/current/aug10/kymcoDowntown300i.htm
Tom is a great guy and rides all sorts of bikes. After all the years he has put on the Gorge rally, I'd consider him a legend in northwest motorcycling. Please check the link. BTW: the pictures are from the rally, not promotional material. Yes, I highly recommend the rally.

Scott
   

2
It looks like the new one has a larger leg shield... Man I wish mine was larger in the ice this winter (and rain). That alone would be worth it. Unless, of course, you can talk the dealer down on the price for the "old" model.

3
Agility 125 / Re: Agility 125 front wheel
« on: February 13, 2008, 03:29:20 AM »

Try some modeling clay, dowel rods and hose clamps. You shouldn't have to go far or fast to get a good recording of the rotor sound.
.

Or there is always duct tape....


Yeah, I'm sure wind noise would be a problem too.

Hummmm..... A referance to Soccer mom and to wind noise. This sounds like dangerous territory.....

4
Agility 125 / Re: Agility 125 front wheel
« on: February 12, 2008, 03:46:47 AM »
I could, but I'm having trouble figuring out how I would hold the phone down by the wheel and drive.....

You all must be more tallented than I.......

5
Agility 125 / Agility 125 front wheel
« on: February 06, 2008, 03:28:00 AM »
The front wheel on my Agility sounds like the brake rotor is warped. I've taken it to the dealer twice. The frist time they said it would go away with wear. 2000 KM later, I took it back into the dealer. This time they said they couldn't hear it. Granted, I did drive the freeway getting there, so it was warm, but It has been a continuous problem.

Has anyone else had this problem? Is there anything else that can be causing this noise??????

6
Agility 125 / Re: Agility 125 Exhaust Bolts Coming Loose
« on: February 06, 2008, 03:23:03 AM »
I managed to lose the bolts on the end of the muffler and also melt part of it. I don't think it likes WOT for very long.

7
Agility 125 / 125 is a heavy hitter - in Europe
« on: January 17, 2008, 09:35:20 PM »
I've been scanning the web and looking at some scooter mags from overseas. It seems that 125's have a huge following in Europe... They seem to be relativly ignored here.... I wonder if there are performance mods we can find in UK for our bikes....

I've also heard that most of the engines are based on the Honda design. Does anyone know what the designation is for the Agility 125 (what is the equivalent Honda engine code)??? Again, are there any toys out there??? Just want it to be able to comfortably run the freeways.... Say, 70MPH or so....

8
Agility 125 / Re: Agility 125 vs other scooters
« on: January 11, 2008, 02:22:34 AM »
This is the Pacific Northwest. The hills make for real seanic riding. But there are lots of them. We go from sea level to 11K feet. So, that can use up 125cc pretty fast..

Hey you two..... what is the speed limit on the highways back there???? We run 70 here, but the traffic always pushes it...

9
Agility 125 / Re: Agility 125 vs other scooters
« on: January 09, 2008, 02:28:28 AM »
It took me 17 years to convence my wife to allow me back on 2 wheels. At the time, we just moved and the 125 was pretty much all the cash I could come up with.

Now I want to upgrade. I find the 125 a kick, but would like just a little more on the freeway. The Agility does it, but anything resembling a hill slows me down (drastically).

I have been shopping the other scoots. I think that a 400 would be great, but some folks in the scooter club (that have 400's) are telling me that a 250 is the sweet spot. I like the cost of the 250's, but it doesn't really save if I'm not happy with it.

10
General Discussion / Fellow 125cc riders
« on: December 19, 2007, 01:14:31 AM »
Although I fully intend to soon upgrade to a Maxi, I currently ride a 125 Agility. How many other 125 riders are out there??? It is a rather odd size, but I know there has to be more than just me.....

Pages: [1]