KymcoForum.com
General => Technical | How To => Topic started by: Mr. Paul on September 02, 2017, 06:36:53 PM
-
1. Use OEM parts only
2. Properly clean the carb
3. Install a new battery
8) 8) 8)
-
8) Yup!
Karl
-
And 4. make sure that your (green) ground wires to engine, frame and battery have always good contact, not being loose or corroded.
A little bit of salt water resistant marine grease in the cable connectors could also help some rainriders or coastriders permanently.
-
Mine would be:
1. Buy EFI only
2 OEM parts
3 Biggest Yuasa fits
Stig
-
Can I add "Do the scheduled maintenance?"
Or "learn how to to the scheduled maintenance?"
Or "Don't just stuff it behind the garage with a partial tank of gas, and leave it there for 6 years, and then tell me it's a crappy scooter because it won't start."
-
1. Use OEM parts only
2. Properly clean the carb
3. Install a new battery
8) 8) 8)
2. Properly clean the carb (Add fuel stabilizer if the bike will not be ridden for a few weeks.)
-
1 Buy a new one.
-
Yes, I'd probably agree with the top 3... redk
-
Change the spark plug.
-
Simple, duck tape and monkey snot.
-
OEM parts (oops) Dr. Pulley is OK though!