Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - vermiselle

Pages: [1]
1
General Discussion / 49cc 2t (red line)?
« on: May 21, 2020, 08:19:01 PM »
What is the (red line) in RPM for a 49cc 2T to be safe? ::)
On my digital RPM, top speed 45mph @ 8900rmp with variator rollers 7.5g.

Thank's

2
Super 8 / Torque spring parts!?
« on: May 20, 2020, 03:35:48 PM »
What is this piece for on the original torque spring?
A restriction?
 I put a new one (polini) and I haven't reinstalled this parts!?

What is it for?




3
Super 8 / 8650 rpm at 45!?
« on: May 16, 2020, 12:50:16 AM »
Hello,
On my Super 8 2013, 50cc with original air box without restriction and main jet #88.
I recently installed a Tecnigas NextR exhaust and a Polini variator with 6.9G rollers who came with.
I saw the first owner installed the red torque spring.
My top speed with this configuration is 73 km/h on GPS (45mph) and digital rpm I installed, indicates 8650 rpm!

Is it too high?

The Tecnigas at this rpm it's a very noisy and the original engine scream a lot for 50cc, i would not damage the engine!

I want to buy Polini torque spring +15% and 7.5G rollers.

Is it a good choice and do you think i will lose performance

Thank's.



4
Super 8 / what is this wire?
« on: May 01, 2020, 02:20:23 PM »
I was checking the regulator and I saw this cable coming out of the cdi box.
What is it used for?





Thank's

5
Super 8 / Super8 headlight ...#$@!$??
« on: April 17, 2020, 11:29:53 PM »
What engineer at Kymco has to think about the front of the Super8 to change the bulbs of the headlight ??? >:(

I wanted to try installing LED bulbs to replace the halogen bulbs!
But I need to dismantle the whole body to the back to access the front bulbs ...

Why so complicated ??? ::)


6
Super 8 / My new exhaust!
« on: December 14, 2019, 04:02:08 PM »
Here is my 2011 Kymco Super 8 2T,



I removed all the restrictions, I bought a Tecnigas Next-R exhaust. I will install it in the spring because it is snowing here in Quebec!



If I keep the 49cc and the original air filter without restriction, what would be the # jet to start?

7
Super 8 / Hi need your help, Super 8 2T from Montreal!
« on: November 02, 2019, 04:54:26 PM »
Hi,
I just buy kymco Super 8 2 Strokes 2011 with 8000km. All original, restriction removed (Variator and exhaust).
I didn't check if they change the main jet!?
The rollers on the original variator are finish, they have flat on 3 rollers (8.2g). For now i put 6.5g on the variator, only this one i have here... Acceleration little bit faster, but motor rpm is higher and it's longer to hit the 55km/h (my top speed)!

What is the best configuration with the stock motor (49cc) to have the better speed!?
I would like 70 km/h!
If i need to change the exhaust system i don't want one too noisy because the police check that here.... Can i stay with the original one!?
Did is it better to change the variator, modify the original air box and change the jet ....

Thank's!

8
Like 50 2T / what jet size should I install?
« on: June 01, 2018, 02:05:26 PM »
For my Kymco Like 50 I ordered a new 19mm carburetor because the original 16mm works badly.
My engine is original 49cc but without restriction (exhaust, air filter...)
In my original carburetor I have # 90 hand jet and # 35 pilot and work fine.
With my new 19mm carb, what jet size should I install?

Keep the #90 and #35 or increase?

Thank you!


9
General Discussion / Maximum RPM with 49cc 2 stroke?
« on: May 18, 2018, 03:53:38 AM »
I install a digital RPM on the scooter today.
I try many mix of rollers weight this weekend to find the best weight.

With a stock 49cc 2 strokes what is the maximum rpm must the engine turn at top speed? 7000­-8000rpm???

Thank's

10
General Discussion / Original Carburetor (2t) no mixture srew!?
« on: May 08, 2018, 03:22:18 PM »
My original carburetor of Like 2t has no mixture screw, only a small cap on it.

Is it possible that the screw is below if i remove the cap?

11
General Discussion / 2 stroke motor on choke!???
« on: May 05, 2018, 03:44:30 PM »
Hi,
When i start my Kymco Like 2 Stroke 2014, the motor turn very fast, too fast i think.?
But when it hot, the idle speed is normal (1600rpm)!?

The original carburator didn't have air screw adjustement .

Is it normal or what i need to do?

My video!




Thank's!

12
General Discussion / CDI on a Kymco Like 50 2t
« on: April 29, 2018, 09:38:58 PM »
Hello,

I have a Kymco Like 50 2t 2014 and i would like to know if the original cdi (30410-LHB3-E10) has a restriction?

I removed all the restrictions of the exhaust, changed the sleeve of the variator and installed a jet #82.
It will change the original rollers weight they are 8.2g.
5.5g is it too light?
Thank you

13
Like 50 2T / My brand new Like 2014 !!!
« on: April 26, 2018, 12:14:01 AM »
Hello i'm from Montreal,
I'm new to the forum and I bought a Kymco Like 2014 2T with only 65 miles! A real chance, the person used it to get his mail only ...
Under the seat off the scooter there is a jet and the sleeve for the variator, never install.

Is there any other restriction on this model?

I will take other pictures and post them later.
Thank you.


Pages: [1]