KymcoForum.com
Scooters - Big Bore => Xciting 500 => Topic started by: telejojo on June 21, 2015, 10:42:17 PM
-
I bought a 2009 500r and it runs great and full of oil but the engine light stays on. I guess some day I will take it to a dealer and see what the code is saying but everything seems fine.Has anybody had this happen?
-
The oil service light comes on every 4000 miles to remind you to change oil. Depress the rubber button on the right side of dash and it will reset.
-
It only has 3400 miles on it.The light is on the left a little pic of an engine the same in a car.
-
Got a repair manual and by the number of flashes and it is the TPS,but it's running fine so I'm not going to worry about it.
-
A reset will most likely sort it out, as I had same issue when I got my XC 500 EFI.
-
How do you reset it?
-
There is a recessed rubber button on dash. Use a thin stick, push in firmly, hold it in continuously for about 1 min. There, fixed.
If it comes back, problem is more serious, workshop time then.
-
Does it need to be running or just on?
-
My mistake, that is oil light procedure.
CELP reset procedure is:
Have a watch or phone with seconds.
Scoot ignition off
Red engine off switch must be ON.
Scoot on centre stand
Side stand up.
Procedure starts now:
Turn ignition ON where dash lights light up.
Wait 10 seconds and then
turn throttle fully open.
After another 10 seconds,
turn throttle fully closed.
CELP flashes x 2 after 5 seconds.
Engine lamp(CELP) is now reset.
Sent from my Samsung Note 3 with Tapatalk
-
It would'nt work battery was low so I put in a new battery and it worked.Thanks................
-
Great news.
Hopefully it never returns.
Sent from my Samsung Note 3 with Tapatalk
-
Sorry could you explain to me turn throttle fully opened & closed
Sent from my SCH-I605 using Tapatalk
-
Yes key must be on, or have bike running to re-set. :-*
-
Thanks![emoji8]
Yes key must be on, or have bike running to re-set. :-*
Sent from my SM-G950U using Tapatalk