Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bism45

Pages: [1] 2
1
MXU / Re: mxu 250 overheating!
« on: July 14, 2015, 01:24:00 PM »
they all have hholes and hoses in the tanks to release any vapour ??

2
MXU / mxu 250 overheating!
« on: July 13, 2015, 09:37:24 PM »
hi all, i run a quad tour business in spain and this year is hotter than ever!! a few of my bikes (all mxu 250) have started to cut out when hot, then start again when they have cooled down, my question is.....is it a problem with the fuel or something when they are so hot ? or is there actually a cut out switch built in that stops them when they are really hot ? strange thing is the temp gauge on the display doesn't show them overheating ? can anyone help please ?.....cheers in advance :)

3
MXU / Re: mxu 250 front steering
« on: March 26, 2015, 11:30:12 PM »
great will do that...thanks for your help :)

4
MXU / Re: mxu 250 front steering
« on: March 20, 2015, 10:41:21 PM »
no....ive got 4 quads the same and they all have the same pressures but they are not wearing down like this one ??

5
MXU / mxu 250 front steering
« on: March 20, 2015, 10:37:31 AM »
hi all, hope someone can help ?
the front tyres on my mxu 250 are worn again! down the middle.... think the tracking is out ?
could someone explain to me please how to correct the tracking ? thanks :)

6
MXU / need more power for my quads ??
« on: August 24, 2014, 12:53:52 PM »
hi all, i run a small quad tour business and i have 4 x mxu 250 quads, they are all 2005 and have had a good run but i need to put a new lease of life back into them ? i change oil,plugs,tyres and clean carbs of course, and renew chains etc...but is there anything more i can do to restore power into them ? i.e..... new pistons....valves.....belts......any suggestions please ....cheers :)

7
MXU / Re: cutting out in reverse
« on: June 21, 2014, 08:19:02 PM »
thanks but no...no switch and i have four more of the same quad and none of the others have this problem ?

8
MXU / Re: mxu 250 engine cutting out
« on: June 21, 2014, 08:17:33 PM »
i have exactly the same problem on mine (same year) but i have 4 x mxu's and only this prob on one, i have cleaned the carb and they have quite new plugs, will def try the other ideas out though....cheers ;0
P.S YOU DIDN'T ANSWER WHAT YOU WERE WEARING LOL

9
MXU / cutting out in reverse
« on: May 27, 2014, 08:14:47 PM »
my mxu 250 cuts out when i put it into reverse and give it throttle but everything else is fine ?? can any one help please ??

10
MXU / mxu 250 spluttering
« on: January 23, 2014, 11:46:19 PM »
hi all. please help..... my mxu 250 is ok driving slow but when i do 30 or more splutters like mad but if i push the throttle and go fast it evens out ? any ideas please ?

11
MXU / mxu 250 cog
« on: December 28, 2013, 08:36:48 PM »
on my quad the large cog on the rear axle that the chain goes round moves back and forwards with your hand (hence i can't tighten the chain properly?) but it don't move on my others,  any one know what the problem is ? cheers.....

12
Technical | How To / kymco mxu 250 cog
« on: December 28, 2013, 12:01:18 PM »
on my quad the large cog on the rear axle that the chain goes round moves back and forwards with your hand (hence i can't tighten the chain properly?) but it don't move on my others,  any one know what the problem is ? cheers.....

13
Technical | How To / kymco mxu 250 struggling?
« on: December 08, 2013, 08:43:51 PM »
hi all, my mxu 250 is coughing and spluttering when i accelerate ?? wheni hold the throttle down full it goes a bit but then does it again each time, im assuming its a fuel thing ?? and can anyone help with what i should do and how to clean the carb ?? thanks :)

14
Technical | How To / battery not charging?
« on: August 04, 2013, 05:09:06 PM »
hi all, my battery should be charging on my mxu 250, the lights show it is but keeps going flat after a few days and it is a new battery, any ideas ??

15
Technical | How To / mxu 250 stalling in reverse
« on: August 04, 2013, 04:57:20 PM »
hi all, anyone know why my kymco mxu 250 stalls when i put it into reverse but not forward ???

Pages: [1] 2