Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bism45

Pages: [1]
1
MXU / mxu 250 overheating!
« on: July 13, 2015, 09:37:24 PM »
hi all, i run a quad tour business in spain and this year is hotter than ever!! a few of my bikes (all mxu 250) have started to cut out when hot, then start again when they have cooled down, my question is.....is it a problem with the fuel or something when they are so hot ? or is there actually a cut out switch built in that stops them when they are really hot ? strange thing is the temp gauge on the display doesn't show them overheating ? can anyone help please ?.....cheers in advance :)

2
MXU / mxu 250 front steering
« on: March 20, 2015, 10:37:31 AM »
hi all, hope someone can help ?
the front tyres on my mxu 250 are worn again! down the middle.... think the tracking is out ?
could someone explain to me please how to correct the tracking ? thanks :)

3
MXU / need more power for my quads ??
« on: August 24, 2014, 12:53:52 PM »
hi all, i run a small quad tour business and i have 4 x mxu 250 quads, they are all 2005 and have had a good run but i need to put a new lease of life back into them ? i change oil,plugs,tyres and clean carbs of course, and renew chains etc...but is there anything more i can do to restore power into them ? i.e..... new pistons....valves.....belts......any suggestions please ....cheers :)

4
MXU / cutting out in reverse
« on: May 27, 2014, 08:14:47 PM »
my mxu 250 cuts out when i put it into reverse and give it throttle but everything else is fine ?? can any one help please ??

5
MXU / mxu 250 spluttering
« on: January 23, 2014, 11:46:19 PM »
hi all. please help..... my mxu 250 is ok driving slow but when i do 30 or more splutters like mad but if i push the throttle and go fast it evens out ? any ideas please ?

6
MXU / mxu 250 cog
« on: December 28, 2013, 08:36:48 PM »
on my quad the large cog on the rear axle that the chain goes round moves back and forwards with your hand (hence i can't tighten the chain properly?) but it don't move on my others,  any one know what the problem is ? cheers.....

7
Technical | How To / kymco mxu 250 cog
« on: December 28, 2013, 12:01:18 PM »
on my quad the large cog on the rear axle that the chain goes round moves back and forwards with your hand (hence i can't tighten the chain properly?) but it don't move on my others,  any one know what the problem is ? cheers.....

8
Technical | How To / kymco mxu 250 struggling?
« on: December 08, 2013, 08:43:51 PM »
hi all, my mxu 250 is coughing and spluttering when i accelerate ?? wheni hold the throttle down full it goes a bit but then does it again each time, im assuming its a fuel thing ?? and can anyone help with what i should do and how to clean the carb ?? thanks :)

9
Technical | How To / battery not charging?
« on: August 04, 2013, 05:09:06 PM »
hi all, my battery should be charging on my mxu 250, the lights show it is but keeps going flat after a few days and it is a new battery, any ideas ??

10
Technical | How To / mxu 250 stalling in reverse
« on: August 04, 2013, 04:57:20 PM »
hi all, anyone know why my kymco mxu 250 stalls when i put it into reverse but not forward ???

11
Technical | How To / kymco mxu 250 repair
« on: July 30, 2013, 01:01:32 PM »
hi all can somebody tell me when you tighten the two nuts on the back axel on the kymco mxu 250 do you tighten the first nut up as tight as it will go ????

Pages: [1]