1
Xciting 250 / Re: Variator chatter
« on: May 01, 2018, 08:42:47 AM »
I've owne an xciting for about two years. I can tell you that I heard those sounds and others. I beleive is quite common. I wouldnt worry about it too much.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Xciting 250 / Re: New member with a troublesome Xciting 250i 2007
« on: March 11, 2018, 09:13:13 PM »Quote
Where is the connector for the Kymco analyzer tool and what does it look like
Right next to the battery, there's a connector covered with some black plastic, on the other side where the fuses are
3
Xciting 250 / Re: Metalic Wierd Noise (Video inside)
« on: March 10, 2018, 07:53:20 AM »Does not sound that way to me. However, I am an old guy and have bionic hearing! Do you notice any wobble in the wheel?
Not at all, only that metallic noise that is driving me mad, perhaps I should take off the exhaust and check if the noise come back...
4
Xciting 250 / Re: Metalic Wierd Noise (Video inside)
« on: March 09, 2018, 08:48:36 PM »
Could be possible that the wheel bearings have gone bad??
5
Xciting 250 / Metalic Wierd Noise (Video inside)
« on: March 09, 2018, 12:54:31 PM »
I been having this wired metalic noise comming from the rear wheel . Im unable to identify where is it comming from or what could cause it. Does anyone have any idea?
https://photos.app.goo.gl/WBwTDOB9Fj5VxGiU2
https://photos.app.goo.gl/WBwTDOB9Fj5VxGiU2
6
Xciting 250 / Re: Kymco Xciting 250 Under Powered
« on: June 01, 2017, 07:35:44 AM »
If I where you I wouldnt even look at the speedometer, In my bike its about 15km/h off . I know that just before the red line in the revolutions counter, its about 100-105 km/h to be accurate. (Measured with speedometer). A worn belt will have quite a big impact in top speed, changing that and the rollers should increase meaningfully the top speed (about 10 to 15 km/h ,more)
7
Xciting 250 / Re: This is what happens when you dont change your scooter belt(13,000Km Mitsobushi)
« on: May 05, 2017, 05:46:16 PM »Congratulations !
Looks as though you have gotten the last nickel of value from that belt !
Where did it give up on you ? I heavy traffic? or windy hill roads?
It's generally considered better to inspect and replace when you do notice performance degrading.
redk
Driving in the highway , moderate traffic, at about 80km/h The scooter turned off instantly after for some reason .
8
Xciting 250 / Re: This is what happens when you dont change your scooter belt(13,000Km Mitsobushi)
« on: May 05, 2017, 05:44:10 PM »
Bando makes original equipment belts for Honda automobiles. In my experience the automotive belts are quality. Hopefully the scooter belts will prove to be the same for you.
I didnt know there's such thing as a Ventilation for this...? If so , where is located??, I guess I have to check this!
9
Xciting 250 / Re: This is what happens when you dont change your scooter belt(13,000Km Mitsobushi)
« on: May 04, 2017, 02:20:09 PM »
I drive mostly on highgway, about 50 km daily . Average of 100km km/h in every commute
10
Xciting 250 / Re: This is what happens when you dont change your scooter belt(13,000Km Mitsobushi)
« on: May 04, 2017, 11:18:03 AM »
I have put a cheap belt as a temporary replacement , a "Bando" . Not sure how much will this one last....
11
Xciting 250 / This is what happens when you dont change your scooter belt(13,000Km Mitsobushi)
« on: May 04, 2017, 09:17:59 AM »12
Xciting 250 / Cvt belt Dimensions?
« on: April 18, 2017, 06:09:12 PM »
Does anyone know what you the exact measurements of the original cvt belt of the kymco xciting 250 Afi?
As well I'm looking for the measurements and weight of the original variator rollers.
Thanks a lot!
As well I'm looking for the measurements and weight of the original variator rollers.
Thanks a lot!
13
Xciting 250 / Re: Rear brake pads xciting 250
« on: January 14, 2017, 09:43:31 AM »
Finally I found out that you only need to push theme out with a screw driver, nothing holding them in place other than a small metalic plate on each side !
14
Xciting 250 / Rear brake pads xciting 250
« on: January 12, 2017, 09:53:26 PM »
Hello, does anyone know how to replace the rear brake pads of the xciting 250? I have seen a ton of videos in the Internet , but I cant seem to get it right
The rear brake pads of my scooter do not have a pin , or screw that holds them in place , the only thing holding theme is a metalic piece on the bottom. Im unable to extract theme from there, how should I do this?
The rear brake pads of my scooter do not have a pin , or screw that holds them in place , the only thing holding theme is a metalic piece on the bottom. Im unable to extract theme from there, how should I do this?
15
Xciting 250 / Re: Air Valve??
« on: December 05, 2016, 07:03:26 AM »
Im unable to find the link for the User manual page 20... Can you make a screenshot? Or leave a link?
Pd:When the bike is running there's air sucction from one of the ends. (The small hose)
I found a more complete picture...
http://www.ebay.co.uk/itm/AIR-VALVE-AIR-VALVE-KYMCO-XCITING-250i-2007-2013-/291807192964?hash=item43f1106784:g:ISoAAOSwbYZXdR8J
Thanks!
Pd:When the bike is running there's air sucction from one of the ends. (The small hose)
I found a more complete picture...
http://www.ebay.co.uk/itm/AIR-VALVE-AIR-VALVE-KYMCO-XCITING-250i-2007-2013-/291807192964?hash=item43f1106784:g:ISoAAOSwbYZXdR8J
Thanks!